Select by appearance: Selects a group of faces of the same appearance. The results will be displayed by using a table (numerical result) and graphical elements inside Inventor graphics area. Rays in X or Y or Z direction are placed at a specified interval and then thickness along these rays is calculated to check if a minimum thickness has been respected. This command checks whether a particular minimum thickness was observed during modeling. MWT: Minimum wall thickness calculation. The thickness is calculated along the surface normal direction at a specific point while you are moving the mouse on top of a 3D part. You can dynamically calculate the thickness of a 3D part at a specific point. Move the mouse on top of a part and you will see the "X-Ray" of the part at that point. X-Ray: You can dynamically section a 3D and/or create a 2D sketch with a section of a 3D part at a specific point. The results will be displayed through a clear table or through a Chart. You can see the mass of a full assembly or of sub-assemblies or of a single occurrence. Sketches, Workfeatures and Surfaces of all occurrences will be switched on or off by clicking a button. You can switch on or off the visibility of occurrences objects. No need to open each single occurrence to export parameters. When parameters are displayed you can modify their value and see the impact of this modification on the assembly. A clear window will display the assembly structure and all of the exported occurrences parameters. You can modify parameters of each occurrence at assembly level.
Most used commands: Toolbox will check the commands you use the most and it will then propose these commands at the right-click of a mouse.Ĭommands available with Assembly environment
You can specify an interval for autosave and, as well, check which are the candidate files for autosave. Auto save: while you are modeling, this function will auto save the modified files.
Open explorer at document position: by right-clicking a document node (occurrence, assembly, etc.) you can open file system explorer at document position. Isolation, highlight and reset behaviour of browser nodes: you can highlight or isolate nodes of a specific type (All fillets, holes, and workplanes etc.) and then reset the browser behaviour. Toolbox is a suite of additional commands for Autodesk® Inventor® which you can use within different environments.Ĭommands available with all environments:
0 kommentar(er)
